Call us on: 01202 717 191

Came FrogAE-P - Double Underground Gate Opener Kit

Image for Came FrogAE-P - Double Underground Gate Opener Kit

Kit Contents

2 x Motor
2 x FoundATIon Box
1 x Frequency Card
2 x Wired Safety Photocells
1 x Control Board
2 x Radio Remote
1 x Antenna
2 x Release Mechanism
1 x Instruction Manual
Product Volt Weight
per leaf
per leaf
per leaf
Type Price Buy
Came FrogAE-P Kit
400 kg
RRP £1,872.00 Save 40%

£1,119.98 inc.vat
Came FrogAE-P24
400 kg
RRP £2,125.44 Save 35%

£1,379.99 inc.vat

The hide-away solution to apply to gates in residential and apartment block settings


  • The underground solution for gate automation.
  • High-grade of protection from enviromental agents (IP67).
  • The system automatically locks back after gate is manually released.
  • Can open as wide as 180 degrees (with 001FL-180).
  • 001FROG-AE and 001FROG-A24E featuring encoder-based technology, tested according to current legislative standards meaning that the product has been tested for compliance with maximum impact for standards EN 12445 & EN 12453.
  • The 24 V version can function in emergency mode during power cuts.
  • Special corrosion resistant all-steel foundation box.
  • Built-in adjustable mechanical stops.


The FROGAE-P comes with the ZM3E control panel.

The FROGAE-P24 comes with the ZL19N control panel.


All underground motors will operate underwater when new, but if left submerged, it is likely that water will eventually enter the motor and / or cable insulation will become porous. It is better to correctly drain the foundation cases from day one to protect your investment! Some additional fabrication/welding may be necessary to connect the drive shoe to your gates.


Remember if fitting underground drivers to wooden gates, it will be necessary to clad the gate bottom edge with metal to spread the load and to give something to attach the motor shoe. If you don't, the push-pull from the high torque will eventually split the wood.


Weight and Width Guide



Optional additional accessories for Came FrogAE-P - Double Underground Gate Opener Kit

Gate Automation Wizard

Optional Accessories

  1. EMIS120 GSM/Wifi Switch

    EMIS120 GSM/Wifi Switch

    from £152.31
  2. ASO 225 TK 25mm Safety Edge - 2000mm

    ASO 225 TK 25mm Safety Edge - 2000mm

    from £115.00
  3. Emergency Stop Button - Twist Release

    Emergency Stop Button - Twist Release

    from £6.73
  4. Electric Lock with Single Cylinder

    Electric Lock with Single Cylinder

    from £107.61
  5. Came DIR-10 Wired Safety Photocells

    Came DIR-10 Wired Safety Photocells

    from £30.75
  6. Came Dbc01 Wireless Photocells No Batteries

    Came Dbc01 Wireless Photocells No Batteries

    from £88.00

Gate Automation

Please select what type of automation you require for your gate/s. Double & Single Swing refer to motors which attach to the gate and pillar of a swing motion gate. Double & Single Underground refer to motors which lay beneath the ground which attach to the hinge end of swing motion gates. Choose Sliding if you require lateral moving gate automation and Wheeled if you require a motor which utilises a wheeled motor to drive your gate/s.

Motor Voltage

There are two types of power outputs to consider - 24v & 230v. If you need a higher number of operations (opened/closed more than 5-6 times in an hour) during peak periods such as the morning and evening, then you may wish to consider a 24v system.

24v systems are more suitable for higher operation levels as they tend to run cooler than 230v gate motors. However, they do cost more in relative terms, so if you only need to open or close the gate 1-5 times an hour then a 230v system might prove more cost-efficient.

24v motors tend to be used on commercial premises, whereas 230v tend to be used on standard domestic properties. The exception to this rule is sliding gate motors where the reverse is true - 24v sliding gate automation systems tend to be for domestic use, 230v for more intense use (commercial/communal).

24v systems can draw power from battery backup systems meaning they can still operate during any mains power cut (a 230v or 3 phase system would need to be opened with a manual release key).

24v systems can also utilise solar power units as a means of charging batteries, allowing you to site gate automation in rural and remote locations where mains power is unavailable.

Specifications can be found for each product from their datasheet. Each datasheet is downloadable from each product page on this website.

Weight of Gate

All electric gate motors operate up to a maximum weight. This is so the gate will operate in a reliable and safe manner. It is essential to know the weight of each gate leaf in order to choose the correct motor for you installation. If you do not know the weight of your gate/s, send us a photo along with the gate/s dimensions and we can advise.

Gate Width

As with weight, gate motors are designed for gates within certain dimensions. The most important dimension is the width of the gate. To ensure you select the right motor to operate your gate you must know the width of each gate that requires automation.

Opening Angle

Each motor has a maximum angle to which it can operate to. Therefore it is important to note how far the gate needs to open in order for a vehicle to enter/exit safely.

Daily Use

The amount of times your gate is used per day is a determining factor when deciding on the right motor for your usage. Motors are designed to operate within a certain capacity (operations per day) so choosing a motor compatible with your desired use is essential for its durability. Select from the options below the number of times (open & closure = 1 x operation) the gate/s will be operated on an average day.